Frequently asked questions
When boring the lowest cake breaks
The edges of the hosts are not bored neatly
The drill is getting very hot and discolours
When boring the ejector remains hanging
When opening the baking equipment the cakes brake
Cleaning of the baking plates of hard covering
The edges of the cakes are not fully backed
The cake remain sticking at the baking plate
When moistening the cakes do not become evenly damp
Try to increase the air circulation, e. g. by a small fan.
When boring the lowest cake breaks
This is a normal procedure. There is always something breaking off the lowest cake.
The edges of the hosts are not bored neatly
The drill is blunt. Please have a look in the operating instructions how re-sharping is to take place.
The drill is getting very hot and discolours
Please check whether the cakes are too dry
In addition, maybe the drill is blunt and must be reground.
When boring the ejector remains hanging
Please check whether the drill has a depression
possibly the hosts are moistened too weakly.
When opening the baking equipment the cakes brake
Please rub the backing plates with emery sands.
Cleaning of the baking plates of hard covering
Hard covering can be removed with citric acid.
The edges of the cakes are not fully backed
– Possibly there was not enough paste poured up
– Gradually increase the paste quantity a little, until the edges of the cake are fully baked
The cake remain sticking at the baking plate
Please clean the baking plate and grease it with genuine bees-wax or with a special baking running wax. You can order these with us.
